Pulp Cleaning suppliers INTRODUCTION Pressure screens are mainly used to separate unacceptable debris or contaminants from desirable fibers in paper pulp. It is accomplished by passing a pulp slurry over a surface with numerous small holes or slots. Most small flexible fibers pass through and are accepted, while the larger particles that cannot pass through are held back or rejected. The CNL inflow pressure screen (rotor outside the screen drum) is an excellent screening device. It has an incredible screening quality, a large capacity, and a low pulp flow pulse. TECHNICAL PARAMETER ModelNominal Area (銕?InletConsistency (%)Capacity-Hole (T/D)Capacity-Slot (T/D)Inlet Pressure (MPa)Motor Power (KW) CNL200.460.15-1.020-4015-250.1-0.415 CNL210.7530-6025-4518.5 CNL225160-10050-7522 CNL221.3270-13055-8022 CNL231.9110-16080-12030 CNL242.54140-260100-16037 CNL2552.77200-300120-2500.1-0.645 CNL253.36250-400150-30045 CNL264.37260-520180-32055 CNL275.37350-600220-40075 CNL286.4420-700260-48090 CNL297.66500-900350-600110 APPLICATION The hole screens are usually located at the front end of the pulping process, also known as coarse screens. The slot screen is situated in the middle or end of the process, also known as the fine screen. It can be used as a pulp screen before paper production. It also serves as an excellent screening machine for wood pulp, straw pulp, and waste paper pulp. WORKING PRINCIPLE CNL series inflow pressure screen is continuing screening equipment under the fully closed position with pressure. When it works, the pulp enters the outside of the screen drum along the tangent direction through the pulp pipe. With the help of the pressure difference between the inside and outside of the screen drum, qualified pulp enters the screen drum through the sieve seam/hole and exits through the pulp pipe. The rejects which can not go through the sieve seam (hole) fall to the bottom and come out from the discharge pipe. Rotating foil on the outside of the screen drum generate a gentle pressure, which improves the circulation flow of the pulp; its tail will create a negative pressure, which affects the backwash sieve seam (hole). It can prevent the sieve seam (hole) congestion, and the pulp can smoothly enter through the sieve screening (hole) from the surface, ensuring continuous operation.Pulp Cleaning suppliers website:http://www.cotecmachine.com/stock-preparation/pulp-cleaning/